ENDO TACTICAL STOCK ADAPTER FOR GLOCK - BLACK

Model TSA-G compatible with REGULAR FRAME (NO SF) GEN 1,2,3 Glock models: G17, G20, G21, G22, G24, G31, G34, G35, G37, and G18

(Stock, receiver extension (buffer tube), castle nut, and receiver plate NOT included)

Features & Benefits Summary:

• Compatible with REGULAR FRAME (NO SF) GEN1-GEN3 Glock models: G17, G20, G21, G22, G24, G31, G34, G35, G37, G18 including the Long (L), Compensated (C), and Rough Textured Frame (RTF) versions of each
• Enjoy the familiarity of using your favorite AR-15 / M16 / M4 shoulder stock
• Compatible with all AR-15 / M16 / M4 receiver endplate sling adapters
• Increased stability when using your handgun
• Greater stability means increased accuracy and control
• Reduces shooter fatigue by re-distributing the felt recoil and weight of the handgun
• Quick and easy to attach (no weapon alterations necessary)
• No interference with the usual operation of your handgun
• Easily concealed under a light jacket when attached to handgun
• Lightweight body made from high strength fiber reinforced thermoplastic
• Stainless steel detent retaining pin, tethered by a stainless steel chain lanyard
• Very solid fit. Adapter feels integral to the handgun
• Enjoy a natural, comfortable shooting position with a stock connectedThe same cheek weld that you are used to on a rifle, should keep your face a safe distance away from the slide
• No tools necessary for installation
• NFA rules apply when adding a stock to a handgun.
• Reference: ATF Form 1
•  Made in the USA

Additional benefits for Law Enforcement

• Can be fielded for a fraction of the cost of a patrol rifle
• Practical for bike patrol, horse mounted officers, marine officers and foot patrol
• Improved tactical abilities in situations where there is no time to wait for SWAT
• Decreased departmental liability & litigation exposure
• Lower additional training costs over patrol rifle use
• Increased officer survivability during critical incidents such as active shooter scenarios

Installing a stock on the adapter

1. Eject magazine, and make sure gun is unloaded
2. Take AR-15 / M16 / M4 buffer tube and thread the castle nut onto it (notches to the rear)
3. Slip receiver plate (notch pointing towards open end of buffer tube) onto the buffer tube
4. Thread the buffer tube (with castle nut & receiver plate) into the adapter
5. When the receiver plate gets close to the adapter line up the notch on it to the corresponding hole in the adapter
6. Turn the castle nut towards the receiver plate in order to snug it up against the adapter
7. Tighten up the castle nut using a stock wrench or your hand.
8. Slip stock of choice onto buffer tube

Attaching the adapter to the Glock

1. Double check that gun is unloaded
2. Remove detent pin from the hole in the adapter insert
3. Insert the pointed end of the adapter into the corresponding hole (behind the magwell) in the backstrap of the Glock
4. Push up on the adapter until it hits the crest on the top of the grip
5. Pull the upper brace of adapter around the crest of the grip, allowing it to fit into plac
6. Firmly push bottom of adapter so that the hole in the backstrap of the Glock lines up with the hole in the adapte
7. While maintaining pressure on the bottom of the adapter, insert the detent pin (using a twisting motion) through the hole in the backstrap of the Glock and through the adapterThe fit is meant to be tight, so this may take some effort!
8. You're ready to rock & roll